Thingiverse
Din Rail Riser- Higher
von steezebe
56
Downloads
37
Likes
0
Makes
This is a remix of the DIN rail rizer by Piloten. I needed a little more clearance for some terminal blocks underneath, so after he uploaded the drawing, I made some minor changes!
The mounting hole can be tapped for a M4x0.7 screw, and a nut can be mounted to the bottom of it in the hole for grounding the rail if necessary.
Print time was about 2:20 for a pair at suggested settings on a CR-10.
Drawing is in millimeters. A taller (50mm height) has been added by request.
The mounting hole can be tapped for a M4x0.7 screw, and a nut can be mounted to the bottom of it in the hole for grounding the rail if necessary.
Print time was about 2:20 for a pair at suggested settings on a CR-10.
Drawing is in millimeters. A taller (50mm height) has been added by request.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!