dingwall 5 string nut

it has a 9,45" radius (240mm), the slottet version is adapted for .045 / .065 / .085 / .105 / .125 strings and for my “low” playing purposes. its a bit longer then it should be so it can be sanded down to the length needed. i also recomend to sand the radiuses down a bit, looks better afterwards. also the thickness is a bit lower, so it doesnt break of the fron wood due to thight fit! i measured out the original one, and they have a string spacing of 8,5mm from middle to middle! If it doesnt fit you i added the rough plank also. not the most beautiful design (made quick and dirty on Tinkercad), but works fine. ive printed it in ASA with 0,12 and 2 perimeters with archimedic infill at 100%. now its time for “sience” which filament sounds best? (eg tungsten, copper, PLA, wood etc) ps: the last photo is the original one from Dingwall.