dipole

This dipole design is setup mostly for an inverted V. The connectors for the antenna wire are angled at 45 degrees but I'm sure it will work fine at any angle. I just designed it with the thought that wire strain relief by angling the pads wasn't a bad thing. I also added a pad between the coax connection tie down holes so the coax has something to rest on without being dragged all the way to the base of the center unit. The top holes are setup for a M5 x 16mm screw and nut and then a M5 x 8mm wing nut. The toroid in my pictures is a FT140-43. Everything else is zip ties basically.

The dipole ends file is meant to have a carabiner in the large hole and the antenna wire in the small ones.

The holes are designed for 20 AWG wire. The green wire in my pics is BNTECHGO 20 awg.

The dipole segment file is if you were to create a linked dipole.

check my pictures or post comments if there are any questions.

Chris - KI6SMR