Thingiverse
Dish Soap holder
von CrackBaby8404
4
Downloads
7
Likes
0
Makes
This is a dish soap holder for Pril soap.
I forgot to add, I printed it with supports from the bed only. However I think it would print fine without supports.
Update: I had this up for a while but it became loose on the wall. I only had it connected with a single screw, perhaps that's the reason. I am going to print it in PETg now. I think this will work out better! Please post your makes!
Update: I printed it with PETG no supports .2 layer and it is so much better. holding for a very long time. PLA is to brittle.
I forgot to add, I printed it with supports from the bed only. However I think it would print fine without supports.
Update: I had this up for a while but it became loose on the wall. I only had it connected with a single screw, perhaps that's the reason. I am going to print it in PETg now. I think this will work out better! Please post your makes!
Update: I printed it with PETG no supports .2 layer and it is so much better. holding for a very long time. PLA is to brittle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
