Thingiverse
DIY PrintRite Cable Chain Setup
door 1sPiRe
231
Downloads
172
Likes
0
Makes
Here is my setup for the cable chain on my DIY PrintRite.
The Z to Y holder is made to be fixed on this.
To make this you will need 4 or 7 5mm steel balls, oil, 2 M3*8 screws (hex socket wished), and a few zip tie.
The Z to Y holder is made to be fixed on this.
To make this you will need 4 or 7 5mm steel balls, oil, 2 M3*8 screws (hex socket wished), and a few zip tie.
1sPiRe publiceert ook op
11 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
