Thingiverse
DJI Controller 3 Joystick Knobs
von 3D_Army_Builder
0
Downloads
0
Likes
0
Makes
A friend wanted me to make some joystick knobs for his controller so this is what I came up with.
Note: If you don't want it to brake when doing any aggressive flying, I recommend printing it on it's side rather than vertically.
Note: If you don't want it to brake when doing any aggressive flying, I recommend printing it on it's side rather than vertically.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
