Thingiverse
DJI Mavic Mini Controller Stick replace (PS4 like)
von Cyclo16R
79
Downloads
50
Likes
0
Makes
Version 2 Update :
- Work now for engine start, the stick can go deeper under the orbit.
- Depending on printing face (from build plate) it will smooth or grippy the thumbs placement.
- Compatible with dualshock 4 stick protections and grip.
It's been one week that I had my Mavic mini and I'm already bored of the controller stick. It hurts my thumbs and is realy not precise.
This is why I made those sticks to replace the originals. The Stick is inspired by the dualshok 4 controller stick witch has a curve bulging center and rounded edge to provided confort and precision.
These make also the stick a way smaller than the original.
It fits out of printing, just insert inside the screw hole. (and remove as convenience)
Hope this will help :)
PS: I couldn't try the emergency position, so make sure you don't need it or you 've tried it before. I'm not responsible if it doesn't work.
Also, I'm not a pro, just an enthousiast that got his first drone recently. I'm als
- Work now for engine start, the stick can go deeper under the orbit.
- Depending on printing face (from build plate) it will smooth or grippy the thumbs placement.
- Compatible with dualshock 4 stick protections and grip.
It's been one week that I had my Mavic mini and I'm already bored of the controller stick. It hurts my thumbs and is realy not precise.
This is why I made those sticks to replace the originals. The Stick is inspired by the dualshok 4 controller stick witch has a curve bulging center and rounded edge to provided confort and precision.
These make also the stick a way smaller than the original.
It fits out of printing, just insert inside the screw hole. (and remove as convenience)
Hope this will help :)
PS: I couldn't try the emergency position, so make sure you don't need it or you 've tried it before. I'm not responsible if it doesn't work.
Also, I'm not a pro, just an enthousiast that got his first drone recently. I'm als
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
