Slicer Discord
Door Magnet – 3D-Druckmodell von Thingiverse Thingiverse

Door Magnet

von ZeAllan
19 Downloads
15 Likes
0 Makes
Zum Modell
Our garden door would open itself a few centimetres if not locked from one side or another. This causes draught, escaping dogs and all kinds of unwanted by-products when we are just in the garden for a bit and don't want to lock the door from the outside.

This bracket keeps the door closed but stille easily pushed open. It uses flat round 20mm diameter neodynium magnet with a hole in the middle. One os affixed to the door and another glued to this bracket. The door is closed and the bracket screwed into place while held in the correct position by the locked door.

The magnet in the bracket is held by 1mm of plastic so that the two magnets don't slam together. If your magnets are too weak, you might want to reduce that distance.

Shetchup source included.

UPDATE: Added version 2 which is a bit smaller on one side and has a lid to cover the mechanics. Version 2 Sketchup file includes the version 1 design.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen