Door Stackers

These stackable pieces attach to a doors' corner to allow you to flip them in place for easy painting and then stack on top of each other for easy storage while they dry. No supports should be required. I printed 10 sets in PLA and they have performed with no issue. Similar tools are available commercially for an exorbitant amount of money. These ones cost roughly 60 grams of filament each, 240 per door. These are set to use a #8 wood screw to attach to the door. The stackers have right angles protruding to allow you to easily find center of a 1&3/8" door, at 2" in from the outside. Using the center finder means same sized doors will stack perfectly every time. Just make sure to only start the screw with the center finder before turning the stacker around to actually fasten it to the door, or the right angles protruding from the model will prevent it from spinning. This side also has finger holds to easily move the door around with a partner. The stackers have tabs protruding from the