Dr.Doom

This print was inspired by the iconic armor-plated look of Dr. Doom. I wanted to capture his cold, mechanical aesthetic with clean surfaces and precise rivet details, and the Kobra S1 Combo handled it beautifully. 🖨️ Printer & Settings Printer: Anycubic Kobra S1 Combo Material: PLA (standard grey) Filament Used: 238 grams Infill: 10 % Print Time: 9 hours Layer Height: 0.2 mm Support: Minimal (chin and mouth areas) Bed Adhesion: Standard textured bed, no warping ⚡ Performance The Kobra S1 Combo maintained great consistency throughout the print — no stringing or layer shifts, even with the mask’s overhangs around the cheek vents and mouth grille. The details around the rivets came out crisp, showing off the printer’s accuracy. 🧩 Post-Processing The mask came right off the build plate with a smooth matte finish. A light sanding and metallic paint job will bring it even closer to the authentic Doom armor look. 💬 Final Thoughts This print proves how capable the Anycubic Kobra S1 Combo is for detailed cosplay and prop projects. If you’re into character masks or large wearable prints, this setup handles long print hours with reliable precision.