Thingiverse
Drag knife for CNC - shapeoko
von Rogoz
97
Downloads
71
Likes
0
Makes
Not tested drag knife based on YouTube videohttps://www.youtube.com/watch?v=-MThK035omE
It should work. Shaft is 6mm. Bearings inside are 625z. There is a magnet and a spring to offset any bumps.
Inventor files are provided
It should work. Shaft is 6mm. Bearings inside are 625z. There is a magnet and a spring to offset any bumps.
Inventor files are provided
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
