Dragon Hueforge

Project: Dragon Hueforge Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm You may print at higher layer heights below the Min Depth of 0.56mm The Max Depth is 2.4mm and the Actual Depth is 2.3mm NOTE: I would change the Wall Generator to Arachne. It takes a while for the slicing time, sometimes I have to leave it on Classic for some of the uploads. Arachne does take longer, but gives better detail on hueforges. (You can leave it on Classic and see if that works the same.) The Model is 234x131.14mm in size. You can scale the X, and Y axes to fit your needs. (Make sure you DO NOT scale the Z axis) Filaments Used: PLA Elegoo Black Transmission Distance: 0.1 PLA Elegoo Red Transmission Distance: 4.3 PLA Elegoo Yellow Transmission Distance: 4.7 PLA Elegoo White Transmission Distance: 3 This print uses 4 unique filaments Swap Instructions: Start with Black At layer #14 (1.2mm) swap to Red At layer #18 (1.52mm) swap to Yellow At layer #21 (1.76mm) swap to White f