Thingiverse
Dragon MicroSD Holder
par bisquick5
9
Téléchargements
5
Likes
0
Makes
A remix of the original Cute Dragon, but with an open slot above the nose for a micro SD card or SD card depending upon your print size.
- Printed at Y = 55mm, scaled proportionally (for microSD size)
- Scaled and sliced in Ultimaker Cura
- No raft, but printed with bridge and original file supports
Note: If you want the microSD to fit vertically in the slot, I would adjust the dragon to be a tad bigger, as at this size it is just a hair too small to fit straight up and down, though I find it looks adorable on an angle!
- Printed at Y = 55mm, scaled proportionally (for microSD size)
- Scaled and sliced in Ultimaker Cura
- No raft, but printed with bridge and original file supports
Note: If you want the microSD to fit vertically in the slot, I would adjust the dragon to be a tad bigger, as at this size it is just a hair too small to fit straight up and down, though I find it looks adorable on an angle!
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !