MakerWorld
Hueforge & Lithophane
Zum Modell
Dragon Pose 3
3
Downloads
12
Likes
2
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.2mm Filaments Used:PLA BambuLab Basic Black Transmission Distance: 0.6PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 5PLA BambuLab Matte Dark Brown Transmission Distance: 2PLA BambuLab Basic Gray Transmission Distance: 2PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 6 unique filaments. Substitute as needed. Swap Instructions:Start with BlackAt layer #2 (0.24mm) swap to RedAt layer #6 (0.56mm) swap to OrangeAt layer #10 (0.88mm) swap to BlackAt layer #16 (1.36mm) swap to Dark BrownAt layer #18 (1.52mm) swap to GrayAt layer #21 (1.76mm) swap to Jade White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercia
Corp veröffentlicht auch auf
338 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!