Dramatic USB Button

Hi everyone!
This is a 3D-printed USB button I created a while back.
As many people asked for the files, I have decided to upload it here.
If you like this project, follow me on Instagram ([@do.robotics](https://www.instagram.com/do.robotics/)).

**What do you need**
- 1 x ATtiny85 development board
- 1 x Resistor (I'm using a 390ohm)
- 1 x SPST momentary push button (normally open)
- 1 x USB Extension Cable (desired length)
- 1 x 3mm screw - used to hold the female USB connector in place.
- Soldering kit
- Jumper wires

**Assembly**
This should be straight forward with the provided images.
Some tips:
- Save some space by soldering the resistor directly to one leg of the resistor.
- Solder the 3 ATtiny pins facing up, as can be seen in the picture.
- Make sure to heat-shrink/wrap everywhere, to avoid shorts.

**Code**
https://github.com/dordchn/usb-button

**Important note**
This may be obvious, but I still want to clarify that building and using the button is