Thingiverse
Drawer with Deviders
von Kimborsting
4
Downloads
2
Likes
0
Makes
designed for full kerf table saw blade to fit the foot
make the cuts with 45 mm in between for good clearance
these models should be printed at 1000% (its my design software)
all sides are 1,5mm thick including the bottom so be careful if you resize to something smaller
make the cuts with 45 mm in between for good clearance
these models should be printed at 1000% (its my design software)
all sides are 1,5mm thick including the bottom so be careful if you resize to something smaller
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
