Slicer Discord
Drawing Dead Insert – 3D-Druckmodell von Thingiverse Thingiverse

Drawing Dead Insert

0 Downloads
0 Likes
0 Makes
Zum Modell
An insert for the Solo Game Of The Month _Drawing Dead_. This was a tough one because the two card sizes didn't fit comfortably together in the box in any orientation. This left little space for any sort of useful tray. If I wanted to optimize fitting in the box and no lid lift, then I'd have essentially been filling the gaps and couldn't sleeve any of the cards. In deciding to take an approach that prioritized setup and improving play I accepted that the original box would require lift. That freed me to embrace sleeves as well. The final decision I made was to “get rid” of the lift by creating a new bottom that fits snuggly into the box top.

Setup should be a breeze.

1. Open box
2. Place deck / token tray on the table in front of you.
3. Grab the characters and choose one. Set the rest aside.
4. Grab the Gates / Bosses / Minions tray and pull out the cards you need for the difficulty you're playing at, along with the 2 Penance tokens.
5. Remaining Gates, Bosses, Minions, and Charact
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

lovehasnologic veröffentlicht auch auf

41 zusätzliche Modelle auf 2 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen