Thingiverse
DripBox
door VoidKiwi
1
Downloads
0
Likes
0
Makes
Do you have something that drips but not enough to bother fixing it? boy do I have the solution for you. The "drip box"™ is the perfect solution for the lazy and poor! just set it under the thing that drips and forget it.
WARNING: only use on things that drip very slowly allowing for the liquid to evaporate before the container fills.
in all seriousness I have a faucet in my upstairs bathroom that was damaged and I can't be bothered to replace it. so instead of spending money and about 20 minutes fixing it. I decided to learn to 3d model and print a suitable receptacle for dripping water.
printed in PLA at 0.16mm with 15% infill at 150% scaling on its side with the lettering facing up
**NOTE: this is a functional print. i do not care what it looks like or how well the inside looks. there was a pretty decent amount of stringing on the inside behind the lettering when i printed. if that bothers you use supports and print on its bottom.
WARNING: only use on things that drip very slowly allowing for the liquid to evaporate before the container fills.
in all seriousness I have a faucet in my upstairs bathroom that was damaged and I can't be bothered to replace it. so instead of spending money and about 20 minutes fixing it. I decided to learn to 3d model and print a suitable receptacle for dripping water.
printed in PLA at 0.16mm with 15% infill at 150% scaling on its side with the lettering facing up
**NOTE: this is a functional print. i do not care what it looks like or how well the inside looks. there was a pretty decent amount of stringing on the inside behind the lettering when i printed. if that bothers you use supports and print on its bottom.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
