Thingiverse
Drone Work Station
von alancastell
26
Downloads
17
Likes
0
Makes
Wanted a stand to work on my racing drones so made this one. I used supports for the front and back ramps which were easy to take off. Printed at 20% fill.
Notches are cut to allow you to change the angle. Works well on mine up to 250 size depending on frame type.
Notches are cut to allow you to change the angle. Works well on mine up to 250 size depending on frame type.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
