Thingiverse
DuneBuggyDash
von nickodemous
7
Downloads
6
Likes
0
Makes
Dashboard augmentation for Powerwheels Dune Racer.
This is part of a larger project and I will post the rest of the required prints and instructions as I go. This dashboard replaces the sticker of a nitro meter with with a functional led dashboard showing two status lights for when the 12v and (new) 6v are connected (ignition on) as well as an output for the boost level use and charging status from the onboard arduino.
Update: 2019-08-05 - v3 - switching to 5mm neopixel through hole LEDs and 8mm chrome LED holders
Update: 2019-08-08 - v4 - move battery status LEDs to make room for speaker. Shrink holes for 6mm LED holders
Update: 2019-08-09 - v5 - Fix curve on bottom for better steering wheel clearance. Shrink speaker support diameter
This is part of a larger project and I will post the rest of the required prints and instructions as I go. This dashboard replaces the sticker of a nitro meter with with a functional led dashboard showing two status lights for when the 12v and (new) 6v are connected (ignition on) as well as an output for the boost level use and charging status from the onboard arduino.
Update: 2019-08-05 - v3 - switching to 5mm neopixel through hole LEDs and 8mm chrome LED holders
Update: 2019-08-08 - v4 - move battery status LEDs to make room for speaker. Shrink holes for 6mm LED holders
Update: 2019-08-09 - v5 - Fix curve on bottom for better steering wheel clearance. Shrink speaker support diameter
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
