Thingiverse
eachine e013 controller nob
von jappie46
2
Downloads
1
Likes
0
Makes
print on 35 % infill 0,2mm layer hight 100mm/s
skirt will do the trick just fine
support put at touching build plate and 90 degrees because only the pillar needs support.
skirt will do the trick just fine
support put at touching build plate and 90 degrees because only the pillar needs support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
