Thingiverse
Jewelry
Zum Modell
Earring
22
Downloads
18
Likes
0
Makes
Height: 50mm (~2 inch)
Width: 26mm (1 inch) at it's widest
If printed flat, no supports needed.
If printed vertically, you'll need a bit of supports around the bottom to give it something to attach to but the interior can print without supports.
Width: 26mm (1 inch) at it's widest
If printed flat, no supports needed.
If printed vertically, you'll need a bit of supports around the bottom to give it something to attach to but the interior can print without supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
