MakerWorld
Decor
Go to Model
Easter Egg Screwable
125
Downloads
14
Likes
57
Makes
Simple screwable easter egg. Perfect for small objects to hide for the easter season. The inside is hollow with a minimum diameter of about 3 cm / 1,18 in at the center. In the top and bottom half the diameter gets a bit bigger after the thread. The first screws are a bit stiff but after a few times it should open and close smoothly. Size: Height: about 7 cm / 2,75 inWidth: about 5 cm / 1,97 in Material: I printed this in PLA and it worked perfectly fine, other materials should work as well but are not tested so far Support: Yes, you can customize the support structure if you want however I found the default support to be working just fine. Printer Settings:Layer Hight: 0,2 mmLayer Width: 0,4 mm
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
