easydriver holder

I have yet to print it, this is a test for a easy driver board holder, simply slide in, the clearance at the front should be enough to allow for solder.

easystepper holder.stl ended up being exactly size for size on my printer. The original dimension for the board were .800 inches wide and a little less then 2 inches long so I rounded that one to 2 inches. I had originally considered shrink would cause it to be about right, I measured and tried to fit it and found it to be size for size with my drawing.

Easydriver holder v2.stl is shrank down to a .75 pocket with the grooves measuring in at .805 in overall width. I will attempt to print this one and see if it's dimensionally sound. I also added a lower platform to v2 that is .05 inches thick, this is to allow for glueing into the enclosure I'm making this for.