Echo Dot Wall Mount

I printed this out of ABS and yes it shrunk so I scaled each part by 1.50mm in all directions

Its not perfect as the cables out the side of the dot are close and end up being buried in the plasterboard. I had to relieve the back side of the plasterboard to allow it to fit.

I used a 92mm hole saw

Dont bother with the hole fixings, I ended up bonding it in place (not the dot jut the bracket).

My advice would be to trial a fit on a peice of 12mm/12.7mm plasterboard before committing yourself to a large hole in your wall!!!!!

I also spray painted the outer ring just so it was bright white.

You may also have to to a little filling with decorators caulk as this one has straight sides but it is very minimal.