echo5mount

Hello, here is my very special version mounting my amazon echo5. With its camera, I want to have a view on my dog, therefore it must turn the echo angle down about 10 or 15degrees. Echo is mounted on the Wall under the window board.

This project was grown. The first prototype bowing down under the weight of echo5, so I had to add the side stabilisationparts, you need 2. To glue them with superglue, is the simplest
solution. You need 2 M3x15 screws for the adjusting body. The ground block is fastened from behind 2holes through Rückwand I used 2 woodsrews with sink head 3x15.
I printed in the worst quality, so the adjusting circle is not so smooth - you need a small file or sandpaper, a flat screwdriver. Also all the corners you should smooth.
Perhaps if its necessary to take a small stripe double sided tape when your echo tends to fall, because the very down angle.

You wonder why it is so wide from the wall - there is the long plug behind the echo!
with the f3d file you can cr