Thingiverse
Edge Pro Magnet Accessory - Retractable
por leadingedge
12
Descargas
6
Likes
0
Makes
This is a retractable magnet accessory for your Edge Pro Apex sharpening system.
The magnet accessory can be
Parts:
1 x Neodymium magnet 20x20x10mm size.
1 x M4 Brass insert
1 x M4 (10mm long) Thumb screw or normal screw (It is used as a handle to retract the magnet accessory and to push it back up when needed.)
Steps:
1- Print the part.
2- Epoxy glue your magnet into the slot in the printed part.
3- Melt your M4 Brass insert into the hole, and install your M4 thumb screw / M4 screw.
4- Remove the screws, nuts and washers of the legs of your Edge Pro Apex.
5- Install the part with the magnet facing down into the slot between the legs of the Edge Pro.
6- Re-install the legs of your Edge Pro Apex with the original screws, nuts and washers.
When you want to have the Edge Pro table magnetised, simply push the magnet accessory up, and when you want to use it without the magnet, simply pull the magnet accessory down. The Edge Pro legs screws are used as stops so you c
The magnet accessory can be
Parts:
1 x Neodymium magnet 20x20x10mm size.
1 x M4 Brass insert
1 x M4 (10mm long) Thumb screw or normal screw (It is used as a handle to retract the magnet accessory and to push it back up when needed.)
Steps:
1- Print the part.
2- Epoxy glue your magnet into the slot in the printed part.
3- Melt your M4 Brass insert into the hole, and install your M4 thumb screw / M4 screw.
4- Remove the screws, nuts and washers of the legs of your Edge Pro Apex.
5- Install the part with the magnet facing down into the slot between the legs of the Edge Pro.
6- Re-install the legs of your Edge Pro Apex with the original screws, nuts and washers.
When you want to have the Edge Pro table magnetised, simply push the magnet accessory up, and when you want to use it without the magnet, simply pull the magnet accessory down. The Edge Pro legs screws are used as stops so you c
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
