Thingiverse
Einhell bits bar holder
von 6FeetsUnder
1
Downloads
0
Likes
0
Makes
Hi all,
After seeing the model of bits older from @plastirat, I thought about a conversion to hold my SGS bits bar.
The bar itself is 18mm tall and 10 mm deep, length does not import.
The srew is an 8mm M4. I have a round head so it scratches a bit again the bar, but not a big problem.
It improved friction and hold the bar in place.
Print on the flat side, with supports (tree recommended)
After seeing the model of bits older from @plastirat, I thought about a conversion to hold my SGS bits bar.
The bar itself is 18mm tall and 10 mm deep, length does not import.
The srew is an 8mm M4. I have a round head so it scratches a bit again the bar, but not a big problem.
It improved friction and hold the bar in place.
Print on the flat side, with supports (tree recommended)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!