Electrical Work Mount

Adding a "old work" single box with side mount tabs to the rear frame of my Ender 3v2 to install a smart outlet that can be controlled to power on and off both my Ender as well as the WiFi box. Using voice commands to run routines, they can be powered on or off sequentially to allow a full boot of the printer prior to WiFi Box take-over. Reverse of this in the power down sequence avoids the WiFi Box from usb reverse powering the display and operating system after the printer has already been shut down.I can also just turn on the WiFi if I wanted to take a look through the camera to make sure my machine was as not being tampered with or manipulated without my consent when in unsecured shared locations.I advise to orient this vertically on it's end and utilize a raft for best results. No supports should be needed. Approximately 4+ hours print time.This object was made in Tinkercad.Edit it online https://www.tinkercad.com/things/lwbqyzoZFNZ