Thingiverse
Electronic Component Stackable Drawers
by otti50
3.2k
Downloads
2k
Likes
3
Makes
This remix offers a set of drawers with a height of 20mm and 40mm and both a width of ~19 cm. You can choose between thin walls (0.8mm) that are easy to print but a little wobbly and sturdier walls that are 1mm wide but require some special slicer settings. Additionally a version with a height of 20mm but only with a width of 16cm.
The shelves for the drawers are identical for the 0.8mm and 1mm variants.
The abbreviations for the file names are *FB* = FrontToBack divider, *LR* = LeftToRight divider. The narrow ones are named with *20s*.
---
# Settings
I print the **1mm** variant with PLA with following Cura-Slicer-settings:
Layer height: 0.3
Init. Layer height: 0.2
Line Width: 0.53
Initial Layer Line Width: 60%
Wall thickness: 1.06mm
Wall Line count: 2
Optimize Wall Print order: Off
Compensate Wall overlaps:Off
Fill gaps between walls: Everywhere
Filter Out tiny gaps:ON
Infill: 10% (Gyroid)
Nozzle-Temp:215C
Bed Temp:40C
Flow:90%
Infill speed: 60m
The shelves for the drawers are identical for the 0.8mm and 1mm variants.
The abbreviations for the file names are *FB* = FrontToBack divider, *LR* = LeftToRight divider. The narrow ones are named with *20s*.
---
# Settings
I print the **1mm** variant with PLA with following Cura-Slicer-settings:
Layer height: 0.3
Init. Layer height: 0.2
Line Width: 0.53
Initial Layer Line Width: 60%
Wall thickness: 1.06mm
Wall Line count: 2
Optimize Wall Print order: Off
Compensate Wall overlaps:Off
Fill gaps between walls: Everywhere
Filter Out tiny gaps:ON
Infill: 10% (Gyroid)
Nozzle-Temp:215C
Bed Temp:40C
Flow:90%
Infill speed: 60m
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
