Electronics Control box

This is a simple electronics control box enclosure that I used on one of my projects that can be seen here: http://www.thingiverse.com/thing:1240527

It is designed around 45x45mm perfboard I got from RadioShack. It may work with other boards but I'm not sure. It would depend on the hole pattern for the posts.

Since the video I drafted the posts so they're tapered which should help prevent needing to widen the holes on the board like I had to.

I designed it so that the gasket is a little bit thicker than the gap allows and it should be printed in ninja flex to clamp down. It honestly, probably doesnt need to be made.