MakerWorld
Electronics
Zum Modell
Electronics enclosure
16
Downloads
5
Likes
7
Makes
Electronics enclosure for your lab! I put in stepdown module and thermostat for my fans in my A1 There is a lot of space for everthing you might need!The lid is secured by 4 magnets ( two 5x10 and 2 10x10) the bigger ones are printed in place ( use pause mode i 235 layer) Boost Me
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
