ELEGOO Centauri Carbon 2 Base Riser

This will raise the height of your printer by 28mm. Overall dimensions are 52mm x 52mm x 496.6mm. I have a very unique situation but others may be able to use this or modify it as needed. WARNING: THE FRONT FEET ARE NOT SUPPORTED FROM BELOW! This is because I used the lip of my counter as point of securement for the base and the feet rest on the lip itself. I have included the STEP files so you can make modifications as needed.

Notes:
-This will need to be split onto two build plates and rotated 45 degrees to fit on the build plate of a CC2. I used dovetails to be sure it was solidly joined when assembled.
-My printer already had rubber anti-vibration feet mounted (in addition to the OEM printer feet) to raise it up slightly above stock height. Stock printers will sit flush on the base itself.
- I added some rubber anti-slip pads (Amazon) to the bottom of the riser itself for a little grip.
-Will most likely work with a CC1 but I have not tested it.