Slicer Discord
Emergency Hull Patch (wall patch) – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Emergency Hull Patch (wall patch)

von Comridor · Decor
1 Downloads
1 Likes
1 Makes
Zum Modell
Ever make a hole in your wall? Maybe a small round one? Perhaps it was from a drywall anchor pulling out, or perhaps “you were cleaning it and it went off”. Doesn't matter! Now you have a hole in your wall and your precious oxygen is leaking out into the cold, uncaring void of space. Wait, you're on a spacecraft or orbital, right? Well, regardless, you can grab one of these premium Emergency Hole Patch kits, dollop some sealant on the back (or glue. Or potato paste.) and smack this bad boy over your recently-created portal to permanently cover it up! Now nobody will know your shame! What do you mean it says “Temporary” right on it and it's extremely obvious? Yes I really have these stuck to my wall to cover up holes from drywall anchors.
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen