Enclosure brackets
von guycoleman
23
Downloads
18
Likes
0
Makes
These brackets are designed to fit any printer. You need to measure your printer to find the aluminium angle iron lengths then attach to these brackets to build your enclosure.
This is designed to be used to attach 25mm aluminium angle iron with a thickness of 2mm
for a box print the following:
1. Corner.stl x8
for a stacked box i.e one box on top of another:
1. Corner.stl x8
2. Divider.stl x4
Designed for 6mm(M6) nuts and bolts
you will need to measure and cut your aluminium angle to lengths and drill m6 holes, be sure to fit and mark on the angle iron where to drill the holes.
Fit your polycarb or clear plastic to the dimensions of your enclosure (don't forget to make a door to access your prints).
*If you print these please share some pictures of your final prints*
This is designed to be used to attach 25mm aluminium angle iron with a thickness of 2mm
for a box print the following:
1. Corner.stl x8
for a stacked box i.e one box on top of another:
1. Corner.stl x8
2. Divider.stl x4
Designed for 6mm(M6) nuts and bolts
you will need to measure and cut your aluminium angle to lengths and drill m6 holes, be sure to fit and mark on the angle iron where to drill the holes.
Fit your polycarb or clear plastic to the dimensions of your enclosure (don't forget to make a door to access your prints).
*If you print these please share some pictures of your final prints*
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
