Ender 3 - Cable support post

Support post to hold ribbon cable connecting extruder etc and sleeved cable connecting print head. Allows full movement of axis without cables snagging.

To install needs short M5 fasteners and 3 small cable ties. Top and bottom clasps do not clamp the cables so they can be moved for final adjustment and trial movement, then the centre cable tie can be used to lock cables in place.

Please note
1. There are no threads in the end of the frame extrusion so they can either be tapped or a notch created in the end of the fastener with a file or hacksaw will help them thread in.
2. When setting up the model in slicer lay the post down on flat side to print, in same orientation as pre assemble pic.