Thingiverse
Ender 3 Runout Sensor Riser
by Kstank
6
Downloads
4
Likes
1
Makes
Upgraded to a Dual Gear Extruder that was higher then the stock runout sensor
bumps it up an additional 10mm to join up with the new dual extruder input
built a riser and a built in bearing for the unit to feed with and prevent rubbing of the filament when feeding from above.
**UPDATED THE BEARING AS I REALIZED THAT IT WAS SLIGHTLY TO LARGE WITH TOLLERANCES SHOULD WORK BETTER NOW FOR EVERYONE
bumps it up an additional 10mm to join up with the new dual extruder input
built a riser and a built in bearing for the unit to feed with and prevent rubbing of the filament when feeding from above.
**UPDATED THE BEARING AS I REALIZED THAT IT WAS SLIGHTLY TO LARGE WITH TOLLERANCES SHOULD WORK BETTER NOW FOR EVERYONE
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!