Thingiverse
Ender 3 Runout Sensor Riser
von Kstank
6
Downloads
4
Likes
1
Makes
Upgraded to a Dual Gear Extruder that was higher then the stock runout sensor
bumps it up an additional 10mm to join up with the new dual extruder input
built a riser and a built in bearing for the unit to feed with and prevent rubbing of the filament when feeding from above.
**UPDATED THE BEARING AS I REALIZED THAT IT WAS SLIGHTLY TO LARGE WITH TOLLERANCES SHOULD WORK BETTER NOW FOR EVERYONE
bumps it up an additional 10mm to join up with the new dual extruder input
built a riser and a built in bearing for the unit to feed with and prevent rubbing of the filament when feeding from above.
**UPDATED THE BEARING AS I REALIZED THAT IT WAS SLIGHTLY TO LARGE WITH TOLLERANCES SHOULD WORK BETTER NOW FOR EVERYONE
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!