Ender 3 Spool Bracket Riser

# Ender 3 Spool Bracket Riser

Raises the *original* Ender filament spool bracket up by 75mm. I needed to raise the spool for my printer because it came into contact with my printer's enclosure. I chose 75mm because it could easily accommodate larger diameter spools.

## Details

The riser is 75mm tall, 73mm wide, and 21mm deep and the base is 5mm thick.

### STL Files
* `ender3-filamentspool-bracket-riser-v2.stl` : 75mm riser with the Ender dragon logo on one side.
* `ender3-filamentspool-bracket-riser-V2-plain.stl`: 75mm riser without the logo
* `ender3-filamentspool-bracket-riser-V2-plain-50mm.stl`: 50mm riser without the logo

## Additional Parts Needed

* M5 nuts X 2
* M5 8mm screws X 2

## Assembly

After printing:

1. Insert each of the M5 nuts into the wells located on the underside of the top of each of the square openings. They *should* snap in and be held in place.
2. Remove the spool bracket with the screws ad t-nuts from your printer.
3. Temporaril