Thingiverse
ENDER 3 V2 RISER
von Niklip117
55
Downloads
28
Likes
0
Makes
REMIXED FROM PREVIOUS DESIGNS BY FONSWERKS & MDAVYDIV:
35mm total height, will raise printer by 25mm when installed with rubber feet on Ender 3 models.
Suggest printing on flat face.
.20mm layer height should be max, designed for .4mm nozzle, no larger than .5mm.
If using basic marlin.
Fit loosened to have clearance with rubber feet.
Removed 1 face to have support-less printing.
Rounded edges for bed adhesion.
Custom fit for T-Slot rails.
Complaint slit to allow for bending of T-slot pin.
35mm total height, will raise printer by 25mm when installed with rubber feet on Ender 3 models.
Suggest printing on flat face.
.20mm layer height should be max, designed for .4mm nozzle, no larger than .5mm.
If using basic marlin.
Fit loosened to have clearance with rubber feet.
Removed 1 face to have support-less printing.
Rounded edges for bed adhesion.
Custom fit for T-Slot rails.
Complaint slit to allow for bending of T-slot pin.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
