Ender 3 Y-Axis Offset Sensor Bracket

Bracket for the Creality Ender 3 which offsets the y-axis limit switch forward (to account for things such as reduced travel due to stepper motor dampers). Uses the standard hardware to attach to the y-axis aluminum.

I chose to use two holes instead of a slot like other designs, as I discovered the slot was flexing just enough to allow the attachment to loosen and wear down after repeated use.

Note: The circuit board attachment holes are currently slightly undersized, and do not print with threads (I had some trouble getting them to model properly). I recommend cutting the threads by screwing one of the original screws into the holes before attempting installation.

This is my first "polished" part that I've gotten as far as publishing - please feel free to comment with suggestions about the part or the information provided with it! :)

There are a few pre-existing designs, which were just shy of far enough forward for the dampers I installed, but which may be a better fit fo