Ender 5 Plus Cable Chain With Mounts

Made this for ender 5 plus to attach cable chain to extruder in a direct drive setup. I could not find anything with key words to find something. So I made it. This is just the brackets to mount cable chain from https://www.thingiverse.com/thing:2920060.. I used version 3 and v2 clip for actual cable chain.


Print cable chain per their instruction
My mounts I printed at 2. layer with 10% infill with no supports

To mount this remove screws from back of extruder and replace with m3 by 40mm screws. You can also replace 2 screws with #6-32 x 3/8.. I did this just to test. The size a bit bigger and wrong thread but still worked.. I use washers to make up space some and was able to get 1-3 small turns out of it which did work for a good while. I since then replaced with proper screws..

As for back part its printed the same and will need 1 t-slot nut to hold it to the rail.

In my case I used 26 chain links. I adjusted my back mount to optimal position to get this to work wit