Ender 5 plus enclosure

This is a page for my Ender 5 plus enclosure, this is still a work in progress. But the bulk of the work is done, other then finalizing the x gantry setup. If I can't get the brushes to work long term I'll probably just drop the sides down to just above the X gantry. I don't recommend using any of the strip brushes on Amazon as I found them too flimsy and probably wouldn't last. And at least a 4" strip brush is recommend.

Full printer build page,
https://www.thingiverse.com/thing:5918002

**All measurements are for reference only, please measure your own printer before cutting. I used three sheets of 24"X48" 2mm thick acrylic (2 for main frame and 1 for top enclosure) and 600mm extrusions.**

Feel free to remix or use what you need, just beware these parts are made to work together so be careful the first time homing your printer and adjust as necessary.

This is influenced by Youtuber Teaching Tech, check his channel out for a video of him installing a similar enclosure on