Thingiverse
Eotech protector
door uggy
5
Downloads
17
Likes
0
Makes
This is a remix of https://www.thingiverse.com/thing:6061737 (thank's to the original author)
In the original version the "glass" has to be glued "*it is assembled by gluing*"
With this remixed version, there is no need of glue. You insert the protective "glass" (polycarbonate etc) into a "groove" of 2mm.
So you need a 2mm thick protective "glass", and you just "slide" it.
(Use the original glass template from R163)
No glue makes the assembly/repair process easier, as you can also replace the protective "glass" very easily on the field if needed.
On the pictures, I applied some "car filler", then some paint on it.
The original design (thank's to the author) fit 99% fine with my HollyWarrior HWO-S1 repro
I printed the way you see on the slicer picture (need few supports)
💡NEW version💡(TPU 3mm) on https://www.printables.com/model/1264414-airsoft-eotech-protector 🕺
In the original version the "glass" has to be glued "*it is assembled by gluing*"
With this remixed version, there is no need of glue. You insert the protective "glass" (polycarbonate etc) into a "groove" of 2mm.
So you need a 2mm thick protective "glass", and you just "slide" it.
(Use the original glass template from R163)
No glue makes the assembly/repair process easier, as you can also replace the protective "glass" very easily on the field if needed.
On the pictures, I applied some "car filler", then some paint on it.
The original design (thank's to the author) fit 99% fine with my HollyWarrior HWO-S1 repro
I printed the way you see on the slicer picture (need few supports)
💡NEW version💡(TPU 3mm) on https://www.printables.com/model/1264414-airsoft-eotech-protector 🕺
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
