Ergodonk

Hardware list
------------------
- 5 x 8mm m3 hex bolt
- 4 x 12mm m3 hex bolt
- 9 x m3 nuts
- 8 x 3/8" rubber feet
- 4 x 8mm rare earth magnets
- 28 x switching diodes
- 28 x cherry-esque switches
- 1x Arduino pro micro
- 1' stipped ethernet cable (for wire)

nuts, bolts, and feet were available at home depot.
Rare earth magnets were picked up at hobby lobby.
electronics can be purchased on amazon.

Most Ergodox/dactyl boards require a lot of support and take a ton of time to print. the ergodonk is a game pad with a similar form factor, designed to be nearly support-free.
You will only need full support on the Arduino holder, and minor support on the keeb body. (Some printers can bridge the Arduino holder cutout, but you may not want to chance it since it's not much support) at .12 layer height, I was able to print the entire thing in about 20 hrs. The arrow keys are shift and Ctrl, they just happened to be the right row in cherry profile.

Assembly notes:
If you u