ESP 01 Programming Cradle

The ESP 01 (ESP 8266 based) is a very nice tiny WiFi-enabled board, it's extreamly useful, especially if you upload new firmware into it.

However, it is not solderless-breadboard friendly and requires connecting and disconnecting wires to switch between normal and flash modes.

So, I designed this little box that does all this for you, one side conencts to 3.3V power, the other to your PC using a serial adapter and in the middle you plug your ESP 01 board, the design is based on my previous [ESP 01 Connector](http://www.thingiverse.com/thing:1729910)

This box features a switch to select normal or falsh mode, a reset button and a little bump on top that doesn't let you plug in your ESP module up side down.

Parts:
* A toggle switch (I used "New original 10pcs 3-Pin SPDT ON-ON Toggle Switch 6A 125VAC" from AliExpress)
* A push button, 6x6x3mm size

The switch fits into the round hole on one side, the push button sits it the small cradle on the other side, see picture with w