Thingiverse
ESP32-E case
di PotatoBoi123
2
Download
9
Likes
0
Makes
A case for ESP32-E from firebeetle. Long story short couldn't find a case for the microcontroller I have as I'm using it to control my LEDs, so I had to do it myself and hopefully, it will be useful for your purposes too.
Case "bottom_full" is the bottom part of the case but instead of a stripe across to hold the board, it's an entire floor for the bottom of the case.
The difference between the wide and narrow top part of the case is wide fits nice between the headers while narrow keeps the board from falling out but also allows for visibility of the board, for things like power LEDs etc.
Should be held together by being push-fit, but if there are problems with that mess around with scaling in slicing software like Cura by like 1%, and for a more permanent solution use appropriate plastic glue.
Slicer settings: whatever works on your printer with the material you are planning to use.
Case "bottom_full" is the bottom part of the case but instead of a stripe across to hold the board, it's an entire floor for the bottom of the case.
The difference between the wide and narrow top part of the case is wide fits nice between the headers while narrow keeps the board from falling out but also allows for visibility of the board, for things like power LEDs etc.
Should be held together by being push-fit, but if there are problems with that mess around with scaling in slicing software like Cura by like 1%, and for a more permanent solution use appropriate plastic glue.
Slicer settings: whatever works on your printer with the material you are planning to use.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
