Thingiverse
Electronics
Ver Modelo
ESP32-S2 Feather TFT Case
52
Descargas
40
Likes
0
Makes
3D print a case for the Adafruit TFT Feather with ESP32-S2.
This dev board features a 1.14 inch display with a Lipo battery charging circuit and battery monitor.
It's has the ESP32-S2 mini module which works with both Arduino or CircuitPython.
We designed and 3D Printed a snap fit case to make a little compact project.
The two buttons on the front are accessible so you can quickly reboot or get into the bootloader.
The STEMMA QT connector is also accessible, so you can daisy chain your sensors and make a portable project.
You can 3D print the parts without any support material using your favorite filament.
This dev board features a 1.14 inch display with a Lipo battery charging circuit and battery monitor.
It's has the ESP32-S2 mini module which works with both Arduino or CircuitPython.
We designed and 3D Printed a snap fit case to make a little compact project.
The two buttons on the front are accessible so you can quickly reboot or get into the bootloader.
The STEMMA QT connector is also accessible, so you can daisy chain your sensors and make a portable project.
You can 3D print the parts without any support material using your favorite filament.
adafruit también publica en
1 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
