Thingiverse
Extruder Spring Preloader
von ybjack
3
Downloads
6
Likes
0
Makes
Please install under the spring of the extruder.
There are 3 types from 1 mm to 3 mm.
Reforcing spring pressure, it resolves the slippage of the extruder.
If the stepper is out of sync, please be careful as it is counterproductive.
I'm tested it with geeetech's MK 8 extruder.
There are 3 types from 1 mm to 3 mm.
Reforcing spring pressure, it resolves the slippage of the extruder.
If the stepper is out of sync, please be careful as it is counterproductive.
I'm tested it with geeetech's MK 8 extruder.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!