F35 (complete model)

The same F-35 model by Rascalgp (An amazing design) but I've joined both parts together to eliminate the visible seam. For best results, I recommend printing the aircraft with the tail facing down as seen in the image above but you can also print it with the nose facing down.

For both of these orientations you will need supports, using tree supports will be ideal with the settings I use for them listed below:

Tree support branch angle: 0.0 degrees
Tree support branch distance: 0.1mm
Tree support branch diameter: 2.0mm
Tree support branch diameter angle: 0.0 degrees
Support placement: Everywhere
Support overhang angle: 0.0 degrees
Brim? Yes

Other settings to consider? Z-Hop and small feature speed (found in experimental section in cura)

Everything else can be left as is to your personal preference, happy printing!


Joined together using Autodesk Meshmixer